Table of Contents
Advertisement
S
/L
CALE
OAD
Single or Dual Cable Scale Configuration Bar Codes
Pole Display Configuration
The following bar codes can be used to configure a Single or
Dual Cable MS2xx0.
The MS2xx0 must be in scale program mode to use these bar codes.
Scale Has Display
³
9
9
Scale Has No Display
³
9
9
C
C
ELL
ONFIGURATION
6
0
0
3
Figure 7. Location of Scale RS485 to Display Connector
6
0
0
4
B
C
AR
Set the scale to use a remote display to
show all scale activity.
A remote display must be plugged into the
Scale RS485 to Display connector on the
MS2xx0 (see Figure 7) for this feature to
function properly.
Set the scale to not use a remote display.
All weights are expected on a POS terminal
display.
A remote display can not be plugged into
the Scale RS485 to Display connector on
the scanner/scale (see Figure 7) or this
feature will not function properly.
ODES
6
Advertisement
Table of Contents
