Operation Modes - Uwatec MANTIS User Manual

Starting a dive when the battery symbol is
blinking can cause the computer to fail during
the dive! Replace the battery before any diving
activity if the blinking battery symbol appears.
When the 'do not dive symbol' appears along
with the battery symbol MANTIS cannot be used
for diving before a fresh battery is installed.
Please refer to the chapter on Checking
the battery status for details how to
manually trigger the battery level check.
Replacing the battery requires opening the
electronic compartment of MANTIS. You must
take extreme care when performing the battery
change operation in order to ensure the water
tightness of the watch. Failing to do so will
cause the watch to flood during your next dive
and permanently ruin it. Damage to MANTIS
due to an improper battery replacement is not
covered by warranty. We strongly recommend
having the battery change operation be carried
out by your SCUBAPRO dive retailer.
See chapter Replacing the battery in
MANTIS in this manual for information on
how to replace the battery.
2.

OPERATION MODES

The reference point for any description
of MANTIS as a watch is the main time of
day display. This is the display in which the
current time is shown on the middle row.
The upper row shows the day of the week
and the date. The example below shows
Thursday, 20th of March and the time is 34
minutes and 9 seconds past 11 o'clock.
6
WARNING
WARNING
The different menu modes are written at the
display like for example: "Watch set". Each
mode may have sub functions and menus.
You can scroll between menus by pressing
+/UP or -/DOWN buttons. Note that
although Menu is written on the display,
you still have not activated the mode. By
pressing the SEL button you activate the
mode and get into the sub menus.
The modes are grouped and described in
this manual in three chapters:
1. MANTIS as a watch
2. Menus and functions at the surface
3. MANTIS as a dive computer
The following chart describes the main
menu structure.
MANTIS USER MANUAL