Changing The Beeper Tone & Volume - Metrologic MS7600 Installation And User Manual

C
HANGING THE
Changing the Beeper Tone
Beeper tones may be programmed directly or incrementally using the following
bar code. The new tone will be heard followed by a short pause. Two more new
tones will be heard signifying the new setting has been stored in memory. The
silent (no beep) tone is also selectable.
Next Beep Tone
³ 9 9 9 9
Changing the Beeper Volume
Volume levels may be programmed directly or incrementally using the following
bar code. The new volume will be heard followed by a short pause. Two more
tones will be heard signifying the new setting has been saved in memory. The
silent (no volume) tone is also selectable.
Next Volume
³ 9 9 9 9
These volume control and beeper tone bar codes can also be found under the
Top plate of the scanner and in the MetroSelect Programming Guide.
Figure 26: Additional Beeper Tone and Volume Control Bar Codes.
B T
EEPER
7 5
7 4
& V
ONE OLUME
25