Audible Indicators - Metrologic MS7120 Orbit Installation And User Manual

A I
UDIBLE NDICATORS
When the MS7120 scanner is in operation, it provides audible feedback.
These sounds indicate the status of the scanner. Eight settings are
available for the tone of the beep (normal, 6 alternate tones and no tone).
To change the tone, refer to the MetroSelect
00-02407B) or the MetroSet2 help files.
One Beep
When the scanner first receives power, the green LED will
turn on, then the red LED will flash and the scanner will beep
once. (The red LED will remain on for the duration of the
beep.) The scanner is now ready to scan.
When the scanner successfully reads a bar code, the red
LED will flash and the scanner beeps once (if programmed to
do so). If the scanner does not beep once and the red light
does not flash, then the bar code has not been successfully
read.
Razzberry Tone
This is a failure indicator. Refer to failure modes page 11.
Three Beeps - during operation
During operation of the scanner, the red LED will flash while
the scanner simultaneously beeps three times (while going
into programming mode).
The red LED will continue to flash until the unit exits program
mode. Upon exiting program mode, the scanner will beep
three times and the red LED will stop flashing. When
configured, 3 beeps can also indicate a communications
timeout during normal scanning mode. When using one-
code-programming, the scanner will beep three times (the
current selected tone), followed by a short pause then by a
high tone and a low tone. This tells the user that the single
configuration bar code has successfully configured the
scanner.
Three Beeps - on power up
This is a failure indicator. Refer to failure modes page 11.
®
Programming Guide (
MLPN
9