Metrologic MS2422 Installation And User Manual page 37

S O
CANNER PERATION
I D
NDICATOR ESCRIPTIONS
Diagnostic Indicator Display
E
RROR
C
ODE
LASER #3 (LEFT HORIZONTAL) UNDERCURRENT WARNING – The laser in the left vertical scanning
29 subsystem is drawing too little current. The laser is probably not on. This could be the result of a loss of the
required set point in memory. Have the unit checked at an authorized service center.
MOTOR #1 (VERTICAL) ERROR – The motor in the vertical scanning subsystem denotes a failure. The scanner
31 will try three times to correct the motor operation. If the motor error persists, the vertical scanning subsystem will
be shut down and this error code will remain on the Diagnostic Indicators.
MOTOR #2 (HORIZONTAL) ERROR – The motor in the horizontal scanning subsystem denotes a failure. The
32 scanner will try three times to correct the motor operation. If the motor error persists, the horizontal scanning
subsystem will be shut down and this error code will remain on the Diagnostic Indicators.
MOTOR #1 (VERTICAL) SPEED ERROR – The motor in the vertical section cannot be speed controlled as
34
desired. Have the unit checked at an authorized service center.
MOTOR #2 (HORIZONTAL) SPEED ERROR – The motor in the horizontal section cannot be speed controlled as
35
desired. Have the unit checked at an authorized service center.
D
ESCRIPTION
33