Rear Axle; Checking The Lubricant Level; Brakes; Test Method - Cushman 29175-G01 Owner's Manual And Service Manual

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
View from underside of vehicle
Fig. 15 Lubrication Points

REAR AXLE

The only maintenance required for the first five years is
the periodic inspection of the lubricant level. The rear
axle is provided with a lubricant level check/fill plug
located on the bottom of the differential. Unless leakage
is evident, the lubricant need only be replaced after five
years.

Checking the Lubricant Level

With the vehicle on level ground, clean the area around
the check/fill plug and remove plug (Ref Fig. 16 on page
11). The correct lubricant level is just below the bottom of
the threaded hole. If lubricant is low, add as required.
Add lubricant slowly until lubricant starts to seep from the
hole. Install the check/fill plug. In the event that the lubri-
cant is to be replaced, the vehicle must be elevated and
the oil pan removed or the oil siphoned out through the
check/fill hole.
ELECTRIC THREE WHEEL SERVICE VEHICLE
Wheel bearings
and fork pivot
Rear axle
check and
fill
Owner's Manual and Service Guide
Fig. 16 Rear Axle Lubricant Check and Fill

BRAKES

Service brakes in accordance with the Periodic Service
Schedule (Ref Fig. 22 on page 16). After the vehicle has
been put into service, it is recommended that the brakes
be checked by performing the following test:

Test Method

!
improperly operating brake system, the braking sys-
tem must be properly maintained. All driving brake
tests must be done in a safe location with regard for
the safety of all personnel.
Over time, a subtle loss of performance may
take place. Therefore, it is important to estab-
lish the normal braking distance with a new vehicle.
Determine the braking performance of the vehicle by
engaging the parking brake at a common point on a flat,
dry, clean paved surface while traveling at maximum
speed (Ref Fig. 17 on page 12). Observe the vehicle
stopping location. If the vehicle stops in a significantly
greater distance than normal or pulls to one side, it
should be tested again.
If the vehicle fails the second test, it should immediately
be removed from service. The vehicle needs to be
inspected by a qualified mechanic.
Check/Fill Plug
To prevent severe injury
!
or death resulting from
operating a vehicle with
Page 11