Fuse Replacement; Controller System Test; Rear Axle; Checking The Lubricant Level - Cushman HAULER PRO 2022 Owner's Manual

Table of Contents

Advertisement

M
AINTENANCE

FUSE REPLACEMENT

NOTICE: Have the vehicle inspected by your
dealer if fuses continue to blow after
they have been replaced.
1.
Lift the seat bottom to access the PDM.
2.
Open the PDM to access the fuses.
3.
Remove the old fuse and replace with a new fuse
of the same type and size.
4.
Fuses are available from a local Distributor, an
authorized Branch or the Service Parts Depart-
ment.

CONTROLLER SYSTEM TEST

At monthly intervals, test the controller by allowing the
vehicle to roll down an incline with the accelerator
pedal released. Braking force should be felt at approx-
imately 2 mph (3 kph) indicating that the system is
functioning. If vehicle speed continues to rise, apply
the brake and have vehicle inspected by a trained
mechanic.

REAR AXLE

The only maintenance necessary for the first five years is the inspection of the rear axle for lubricant leakage. Unless
leakage is visible, the lubricant needs to be replaced after five years. Refer to the Service and Repair Manual for the
fluid replacement procedure.
Change the axle oil at the intervals indicated in the SCHEDULED MAINTENANCE CHART on page 42.

Checking the Lubricant Level

Clean the area around the check/fill plug and remove the plug. The correct lubricant level is just below the bottom of
the threaded hole. If lubricant is low, add lubricant as required. Add lubricant slowly until lubricant starts to seep from
the hole. Install the check/fill plug. In the event that the lubricant is to be replaced, the oil pan must be removed or the
oil siphoned through the check/fill hole.

LUBRICATION

Do not use more than three pumps of
grease in a grease fitting at any one time.
Excess grease can cause grease seals to
fail, or allow grease into areas that could damage compo-
nents.
Putting more than three pumps of grease in a grease fitting
could damage grease seals and cause premature bearing fail-
ure.
Lubricate components at the intervals indicated in the SCHED-
ULED MAINTENANCE CHART on page 42.
48
58V, 10A Mini Fuse
12V, 20A Relay
A17
32V, 10A Mini Fuse
32V, 5A Mini Fuse
King Pin
Rack Ball Joint
View from Underside of Vehicle
32V, 10A Mini Fuse
Throttle
Resistor
32V, 15A Mini Fuse

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents