Table of Contents
Advertisement
PROGRAMMING SUBSEQUENT DAYS.
YOU NOW HAVE TWO OPTIONS. The first option programs each day independently, while the
second allows Monday's entire program to be 'copied' to one or more other days of the week.
Whether you take the first or second option, you must move directly to it after completing step 8
above. A delay of more than 20 seconds will end the programming procedure.
OPTION 1
PROGRAMMING EACH DAY INDEPENDENTLY.
9A • Press and release the PROG button. The display will
show Tuesday's period 1 starting time. The '+' and '–'
buttons can be used to adjust this, just as in step 3 above.
Steps 4 to 8 above can then be followed to set the rest of the
Tuesday program, followed by Wednesday etc. etc. for the
whole week.
OR
OPTION 2
COPYING YOUR PROGRAM TO OTHER DAYS
9B • Press and hold the PROG button for at least 3
seconds. The display will show MO and TU, with the TU
symbol flashing to indicate that the automatic copying
feature is activated. If you want to copy Monday's program
to Tuesday, press the '–' button. If you want to select any
other day or days of the week to have Monday's program,
press the '+' button as necessary until the desired day starts
flashing, and then press the '–' button to confirm the
transfer. Repeat for any other desired day. When you reach a
day for which you require a different program, simply carry
out steps a described in 3 to 8 above to set the various times
and temperatures for that day.
NOTE. The programming mode will automatically exit at any stage 20 seconds after the last key
activity.
REVIEWING THE PROGRAM
• With the remote in PROG mode, (the ON may not be showing), hold down the PROG button for at
least 3 seconds. Then press the PROG button momentarily and repeatedly to step through the various
programmed values which can be checked as you go, but do not hesitate more than 20 seconds at
each step or the program will exit automatically.
OPERATING IN THE PROGRAM MODE
• Make sure the pilot has been alight for at least 45 seconds (all models except EIS), the slide switch
on the receiver is set to REMOTE, that the mains supply to the receiver power pack (if fitted) is ON,
and that the flame controls on the heater are not set to PILOT or OFF.
• Check that the day and time display on the remote handpiece are correct. Press the ON/OFF button,
and the AUTO/MAN button, if necessary, until the display shows PROG. Note that the OFF display
may still be showing when PROG is displayed. This does not indicate that the remote control is
inactive, but that the present time is outside the programmed periods for the day.
• Place the remote control where it can sense the room temperature accurately, not near the heater,
under a strong lamp or in sunshine. If wall mounting is desired, use the slide-on bracket supplied.
• Note that, to minimise cycling, the signal from the remote is transmitted at three minute intervals in
the AUTO and PROG modes.
© Masport Ltd. 2004
MO
8
591658.d.0
ON
TU
PROG 1
FLASHING
ON
FLASHING
TU
PROG 1
28/07/04
Advertisement
Table of Contents
