Low Batteries; Fahrenheit Temperatures - Masport Climate Pilot Owner's Manual

• To stop the heater from responding to the remote control, simply press the ON/OFF button to
extinguish the PROG display.
• THREE POSITION SWITCH. At any time the remote control can be disabled from operating the
heater by sliding the switch on the receiver to OFF. Sliding the switch to ON will start the heater
independently of the remote handpiece. This can be useful in the event of battery failure in the
handpiece.

LOW BATTERIES

When the batteries in the handpiece are low, the battery symbol on the display will flash. Replace the
batteries (two AAA alkaline). If the batteries fail, the control will shut down the ECS system safely.
When the indicator light in the receiver flashes brightly replace the batteries with four alkaline AA
cells. To access the batteries, press in the front of the battery tray firmly and then release it. The tray
should then protrude slightly, allowing it to be withdrawn. Slide the cover off the battery tray, fit
fresh batteries, re-fit the cover and slide the tray into its holder, pressing it in firmly until it 'clicks'.

FAHRENHEIT TEMPERATURES

To change the display from Celsius to Fahrenheit or vice versa,
• Switch OFF the remote, (making sure PROG is not displayed).
• Hold down the '–' button.
• While holding down the '–' button, press and release the '+' button.
The remote will hold its selected temperature type even when the batteries are replaced.
© Masport Ltd. 2004 9 591658.d.0 28/07/04