Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Masport Climate Pilot
Summary of Contents for Masport Climate Pilot
- Page 1 © Masport Ltd. 2004 591658.d.0 28/07/04...
-
Page 2: Table Of Contents
Period 2: Finish time ..........7 Period 2: Set temperature ........7 Programming subsequent days ......8 Reviewing the program......... 8 Operating in PROG Mode ........8 Low Batteries..............9 Fahrenheit Temperatures ..........9 © Masport Ltd. 2004 591658.d.0 28/07/04... -
Page 3: Introduction
INTRODUCTION The Masport Climate Pilot has a thermostat in the handpiece which turns the fire on and off to maintain a desired room temperature. The temperature setting can be programmed to give different room temperatures during two selected periods of each day of the week. Unlike the Masport ECS II Control System, the Climate Pilot does not vary the flame height or control the heater fan. -
Page 4: Setting The Time And Day
• Press the ‘+’ button to advance the day, and the ‘–’ button to go to the previous day. • Ten seconds after the last day adjustment, the remote will automatically exit the clock setting sequence, or instead you can hold the TIME button for 3 seconds to exit the sequence. © Masport Ltd. 2004 591658.d.0 28/07/04... -
Page 5: Teaching The Receiver
(if fitted, see Note) will signal the fan to start. It will run at whatever speed has been selected at the FAN switch on the heater. If the fan switch has been set to OFF, the fan will not start. © Masport Ltd. 2004 591658.d.0... -
Page 6: Operating In Manual Mode
OFF. Sliding the switch to ON will start the heater independently of the remote handpiece. This can be useful in the event of battery failure in the handpiece. © Masport Ltd. 2004 591658.d.0 28/07/04... -
Page 7: Program Mode
TEMP, MO, PROG 1 and the finishing time of Monday’s PROG 1 period 1. The ‘+’ and ‘–’ buttons can be used to adjust the finishing time as described in the previous paragraph. FLASHING © Masport Ltd. 2004 591658.d.0 28/07/04... -
Page 8: Period 1: Set Temperature
PROG button. The display will show ON, MO, SET SET PROG 2 PROG 2 and the SET temperature for Monday’s period 2. The ‘+’ and ‘–’ buttons can be used to adjust this as before. © Masport Ltd. 2004 591658.d.0 28/07/04... -
Page 9: Programming Subsequent Days
If wall mounting is desired, use the slide-on bracket supplied. • Note that, to minimise cycling, the signal from the remote is transmitted at three minute intervals in the AUTO and PROG modes. © Masport Ltd. 2004 591658.d.0 28/07/04... -
Page 10: Low Batteries
• Switch OFF the remote, (making sure PROG is not displayed). • Hold down the ‘–’ button. • While holding down the ‘–’ button, press and release the ‘+’ button. The remote will hold its selected temperature type even when the batteries are replaced. © Masport Ltd. 2004 591658.d.0 28/07/04...