Setting The Time And Day - Masport Climate Pilot Owner's Manual

2. The receiver operates on either four AA alkaline batteries (expected battery life about 12 months) or
a 6 volt DC (500 mA) mains adapter (not included) may be used instead of the batteries. The
connecting plug must have a positive centre contact (for a 2.1 dia. pin) and a 5.5 dia. outer body. To
withdraw the battery tray, press in firmly on its front face and then release it. The tray should then
protrude slightly and it can be pulled clear. After fitting the batteries slide it in and press firmly until it
'clicks'.
3. Fit the wires from the receiver to the gas valve
terminals marked TH (using the spade connectors), or
cut and strip the wires to connect them to the
thermostat terminals which are either on the rear of
the cabinet or behind the grille on in-built models. If
there is a jumper wire across the thermostat terminals,
remove and discard it.
4. If there is no display on the handpiece panel, check the batteries (2 AAA alkaline). To gain access to
the battery compartment, slip the wall storage bracket off the bottom of the remote (if necessary),
and slide open the battery compartment cover on the rear of the remote. A set of batteries should
give 12 months service.
CAUTION.
The control handpiece incorporates the thermostat, to sense the room temperature, so care should be
taken when using it in the AUTO or PROGRAM modes to hold it no longer than necessary (your
body temperature may mislead the temperature sensing bulb), and to put it down where it can sense
the real room temperature, not in the sunshine, or under a cushion or magazine. A slide-on storage
bracket is supplied to wall-mount the remote control handpiece if you prefer.
• When switched OFF, the display will show the day of the week,
the time, the room temperature and OFF.

SETTING THE TIME AND DAY

• If the indicated time and day are incorrect,
press the ON/OFF button. The display will
now show one of the three operating
modes (MANUAL, AUTO or PROG).
The OFF display will change to ON except
that sometimes in the PROG mode the
OFF display will remain. Note that the
flame symbol may also be displayed.
• Hold down the TIME button (for three
seconds). The time display will flash.
• Press the '+' button to advance the HOUR display and the '–' button to advance the minute display.
In both cases, holding down the button for more than three seconds will cause the setting to scroll
through the numbers. If you overshoot the required number, continue on through a full cycle.
• Having set the clock as described, press the TIME button and the time display will cease flashing
while the day of the week display will flash instead.
• Press the '+' button to advance the day, and the '–' button to go to the previous day.
• Ten seconds after the last day adjustment, the remote will automatically exit the clock setting
sequence, or instead you can hold the TIME button for 3 seconds to exit the sequence.
© Masport Ltd. 2004
SIT 820 Valve
3 591658.d.0
CONNECT RECEIVER
CABLE TO THESE
TWO TERMINALS
Gas Outlet
OFF
OFF
AUTO
28/07/04
PROG