Program Mode; Programming; Period 1: Start Time; Period 1: Finish Time - Masport Climate Pilot Owner's Manual

PROGRAM MODE

This mode allows you to have different AUTO settings for different times of the day and for different
days of the week. For example, you might wish to turn the fire on for two hours in the morning and
for four hours in the evening. You may want a different room temperature for each of these, and you
may wish to vary your time and temperature requirements from one day of the week to another. The
program allows you to select two different time periods per day for each of the seven days of the
week, and to have different SET temperatures for each of the fourteen periods. Of course, they need
not all be different. You will be likely to have weekday requirements different from week-end
requirements, and the programming system permits the settings for one day to be transferred easily to
other days as well. If you prefer not to set your own program, simply press and hold the PRESET
button for ten seconds while the handpiece is ON in the PROGRAM mode to install the factory set
program.

PROGRAMMING

1 • Press the ON/OFF button until MANUAL, AUTO or
PROG is displayed (The OFF display may still be showing
when PROG is displayed).
2 • Repeatedly press the AUTO/MAN button if necessary
until PROG is displayed.
3 • PERIOD 1: START TIME. Press and hold the PROG
button for at least 3 seconds. This commences programming.
The display will show ON, the ROOM TEMP, PROG 1,
MO and the starting time for Monday's first period. The '+'
and '–' buttons can be used to adjust the starting time of
period 1 while the display is flashing. As before, the '+'
button advances the hour figure, while the '–' button
advances the minute figure. If you overshoot the desired
setting, continue on for a complete cycle to get the desired
time.
Make any adjustments or move to the next step promptly, as the programming system exits
after any 20 second delay during the whole of the programming exercise.
If you want to leave the programming mode at any time, simply wait 20 seconds for the display
to cease flashing.
4 • PERIOD 1: FINISH TIME. Press and release the
PROG button. The display will show OFF, the ROOM
TEMP, MO, PROG 1 and the finishing time of Monday's
period 1. The '+' and '–' buttons can be used to adjust the
finishing time as described in the previous paragraph.
© Masport Ltd. 2004 6 591658.d.0
OFF
PROG
ON
MO
PROG 1
FLASHING
OFF
MO
PROG 1
FLASHING
28/07/04