Teaching The Receiver; Manual Mode - Masport Climate Pilot Owner's Manual

TEACHING THE RECEIVER

Before using the remote control for the first time, you must 'teach' the receiver to recognise and
respond to only this particular remote control.
• Set the remote to OFF by pressing the ON/OFF button if necessary. OFF should be displayed. (If
PROG is also displayed, press ON/OFF once more).
• Make sure the four AA batteries are fitted in the receiver, or if
you have the optional mains power supply for your receiver,
turn ON the mains power to the power supply.
• Slide the switch on the receiver to OFF, and then set it to
REMOTE.
• Immediately press and hold both the PRESET and PROG
buttons for ten seconds (with the remote still switched OFF).
The display will show 'LC', and then revert to the normal OFF
display. If the fire lights during this procedure, press the
ON/OFF button twice to revert to normal operation.

MANUAL MODE

In this mode the fire can be controlled entirely by pressing buttons on the remote and the thermostat
is inactive.
• Check that the slide switch on the receiver is set to REMOTE, the power to the heater (and the
receiver mains supply unit, if fitted) is switched ON. Check that the gas tap is turned ON.
• For all models except EIS ones, light
the pilot in the usual way, remembering
that several attempts may be necessary
to clear air from the gas pipeline. Turn
the control knob on the valve to the ON
position and wait 45 seconds.
• Press the ON/OFF button on the
handpiece. The display will now show
one of three modes — MANUAL,
AUTO or PROG plus possibly the flame
symbol. In PROG mode, the OFF may
not change to ON, but the word PROG
will be displayed.
• If necessary, press the AUTO/MAN button repeatedly to step through the three modes (MANUAL >
AUTO > PROG > MANUAL etc.) until you reach MANUAL. In this mode the thermostat in the
handpiece is disabled and the flame symbol will be showing.
• As soon as the flame symbol is showing, the ignition sequence will
commence provided that the POWER switch on the fascia (Sofia and
Madrid models) is not set to OFF. On EIS models, after a deliberate
time delay (about 7 seconds), the ignition sparking will commence. If
gas is available, the fire will light at the flame height selected on the
heater controls.
• EIS MODELS. The first time you attempt to light the fire there will probably be air in the pipeline, so
flame may not appear before the spark shuts down after about 30 seconds. If this happens, press the
ON/OFF button and the flame symbol on the display will disappear. Then press the ON/OFF button
again to restore the flame symbol when a further ignition cycle will commence. (Don't forget the 7
second delay between the remote calling for ignition and spark commencement). Repeat as necessary
until the gas comes through and the fire lights.
• ALL MODELS. After the fire has warmed up (about 10 minutes on HIGH), the Thermodisc in the
heater (if fitted, see Note) will signal the fan to start. It will run at whatever speed has been selected
at the FAN switch on the heater. If the fan switch has been set to OFF, the fan will not start.
© Masport Ltd. 2004 4 591658.d.0
OFF
AUTO
28/07/04
PROG