Masport ECS II Series Owner's Manual
  1. Manuals
  2. Brands
  3. Masport Manuals
  4. Remote Control
  5. ECS II Series
  6. Owner's manual
Masport ECS II Series Owner's Manual

Masport ECS II Series Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading

Related Manuals for Masport ECS II Series

Summary of Contents for Masport ECS II Series

  • Page 2: Table Of Contents

    ECS II CONTROL SYSTEM ON/OFF shows the activity status of Symbol indicates that a signal the remote in MANUAL & AUTO modes is being sent to the receiver. — indicates the start and finish of periods when programming. Calendar shows the present day or Battery symbol flashes when the day selected while programming.

  • Page 3: Introduction

    INTRODUCTION ECS II models have a radio frequency (RF) control system which can operate in three modes – MANUAL, AUTO and PROGRAM. The RF system has the advantage that the remote control does not need to be aimed directly at the heater. The control handpiece incorporates the thermostat, to sense the room temperature, so care should be taken when using it in the AUTO or PROGRAM modes not to hold it longer than necessary (your body temperature may mislead the temperature sensing bulb), and to put it down where it can sense the real room temperature, not under a cushion...

  • Page 4: Manual Mode

    MANUAL MODE In this mode the fire is controlled entirely by pressing buttons on the remote and the thermostat is inactive. • Check that the power to the heater is switched ON and that the gas tap is turned ON. •...

  • Page 5: Operating In Manual Mode

    • Once the flame symbol appears on the display, the fan speed can be selected. Repeated pressing of the button will step the fan speed through its three speeds and OFF setting. Pressing the fan button when the fan has been set for its highest speed will turn the fan off.

  • Page 6: Operating In Auto Mode

    • If the set temperature exceeds the current room temperature the flame symbol will show, increasing in size as the difference between the two increases. When operating in AUTO mode, the heater flame will be larger if the room temperature is well below the SET temperature, and it will decrease as the room nears the SET temperature.

  • Page 7: Period 1: Finish Time

    4 • PERIOD 1: FINISH TIME. Press and release the PROG button. The display will show OFF, the ROOM TEMP, MO, PROG 1 and the finishing time of Monday’s PROG 1 period 1. The ‘+’ and ‘–’ buttons can be used to adjust the FLASHING finishing time as described in the previous paragraph.

  • Page 8: Reviewing The Program

    • Switch OFF the remote, (making sure PROG is not displayed). • Hold down the ‘–’ button. • While holding down the ‘–’ button, press and release the ‘+’ button. The remote will hold its selected temperature type even when the batteries are replaced. © Masport Ltd. 2004...

Table of Contents