Electrical Connection - Miele PW 6080 VARIO Operating And Installation Instructions

Installation

Electrical connection

Depending on version this machine is
supplied with a connection cable
without a plug.
,
The voltage, rated load and fuse
rating are given on the data plate.
Please ensure these match the site
mains supply.
Connection to the electricity supply
must only be carried out by a suitably
qualified and competent person in strict
accordance with current local and
national safety regulations (BS 7671 in
the UK).
,
Connection should be made via
a suitable isolator or plug. This must
be easily accessible for
disconnecting the machine from the
electrical supply.
For the benefit of future servicing and
testing of the machine, we recommend
connection via a suitable IPX44 plug.
If the machine is hard-wired, provision
must be made on site to switch off all
poles. Switches with a minimum all-pole
contact gap greater than 3 mm are
suitable for isolating the machine.
These include circuit breakers, fuses
and protective devices.
For extra safety it is advisable to protect
this machine with a residual current
device (RCD) with a trip current of 30
mA.
56
Any changes to the electrical
installation, including fitting or replacing
circuit breakers and fuses and
replacing the mains connection cable,
must be carried out by an approved
electrician to ensure compliance with
all local and national electrical safety
requirements.
,
The machine must be connected
to a permanent electricity supply so
that the door can always be opened.
For this reason, it must not be
connected to devices such as timers
which would switch it off
automatically.
Important UK
The wires in the mains lead are
coloured in accordance with the
following code:
Green/yellow = earth
Blue = neutral
Brown or Black = live
WARNING:
THIS APPLIANCE
MUST BE EARTHED