Maintenance Schedule - Husqvarna 543RBS Operator's Manual

H1155319-26,543RBS.fm Page 53 Wednesday, June 24, 2015 10:20 AM

Maintenance schedule

The following is a list of the maintenance steps that must be performed on the machine. Most of the items are described
in the Maintenance section. The user must only carry out the maintenance and service work described in this Operator's
Manual. More extensive work must be carried out by an authorized service workshop.
Maintenance
Clean the outside of the machine.
Check that the harness is not damaged.
Make sure the throttle trigger lock and the throttle function
correctly from a safety point of view.
Check that the handle and handlebar are undamaged and
secured correctly.
Check that the stop switch works correctly.
Check that the cutting attachment does not rotate at idle.
Clean the air filter. Replace if necessary.
Check that the guard is undamaged and not cracked. Replace
the guard if it has been exposed to impact or is cracked.
Check that the blade is correctly centred, is sharp, and is not
cracked. An off-centre blade will cause vibration that could result
in damage to the machine.
Check that the trimmer head is undamaged and not cracked.
Replace the trimmer head if necessary.
Check that the locking nut of the cutting equipment is tighten
correctly.
Check that the transport guard for the blade is intact and that it
can be secured correctly.
Check that nuts and screws are tight.
Check that there are no fuel leaks from the engine, tank or fuel
lines.
Check the starter and starter cord.
Check that the vibration damping elements are not damaged.
Clean the outside of the spark plug. Remove it and check the
electrode gap. Adjust the gap to 0,9-1,0 mm or replace the spark
plug. Check that the spark plug is fitted with a suppressor.
Clean the machine's cooling system.
Clean the outside of the carburettor and the space around it.
Check that the bevel gear is filled three-quarters full with
lubricant. Fill if necessary using special grease.
Check the fuel filter for contamination and the fuel hose for cracks
or other defects. Replace if necessary.
Check all cables and connections.
Check the clutch, clutch springs and the clutch drum for wear.
Replace if necessary by an autorized service workshop.
Replace the spark plug. Check that the spark plug is fitted with a
suppressor.
Lubricate the drive axle with Husqvarna drive axle grease.
MAINTENANCE
Daily
maintenance
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Weekly Monthly
maintenance maintenance
X
X
X
X
X
X
X
X
X
X
Do this every six months.
English – 53