Fitting The Transport Guard; Adjusting The Harness And Brush Cutter - Husqvarna 543RBS Operator's Manual

H1155319-26,543RBS.fm Page 40 Wednesday, June 24, 2015 10:20 AM
in the opposite direction to the direction of rotation
(Caution! left-hand thread).
G
C
Fitting the trimmer guard and trimmer
head
• Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard
extension is fitted.
L
M
C
A
• Hook the trimmer guard/combination guard onto the
fitting on the shaft and secure with the bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
H
• To dismantle, follow the instructions in the reverse
order.
40 – English
ASSEMBLY
E
F
D
B
H
A
B
M L

Fitting the transport guard

• Insert the blade in the transport guard (A).
• Snap the two fasteners (B) into the slots (C) to secure
the transport guard.
Adjusting the harness and brush
cutter
Adjusting the backplate height
• Loosen the two fasteners holding the backplate.
• Loosen the backplate from the frame on one side.