Metra Electronics 99-3410 Installation Instructions

ALL VEHICLES
3
Fig. A
Fig. B
Slide the
2-SHAFT HEAD UNITS:
aftermarket head unit into the kit and
secure with shaft nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the
shaft supports. Slide the DIN cage into the
and secure by bending the
Radio Housing
metal locking tabs down. Slide the
aftermarket head unit into the cage until
secure. (see Fig. B)
5
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
3
4
Fig. A
Fig. B
IF AN EQUALIZER WILL BE INCLUDED :
Slide the aftermarket equalizer into the back of
the Radio Housing. Using the hardware
included with the equalizer, mount the unit to
the kit. (see Fig. A)
IF AN EQUALIZER WILL NOT BE
Snap the Equalizer Dummy
INCLUDED:
Plate into the Radio Housing.
(see Fig. B)
6
Re-connect the battery terminal and test the unit
for proper operation. Slide (4) Speed Clips
the holes in the sub-dash mounting brackets and
mount the head unit/kit assembly with (4) Phillips
supplied.
Pan-Head Screws
REV. 07-29-09
KIT FEATURES
Shaft and
DIN unit
provisions
Equalizer
provisions
KIT COMPONENTS
Radio Housing
Equalizer
Dummy Plate
(4) #8 x 1" Phillips
Pan-Head Screws
(4) Speed Clips
TOOLS REQUIRED
Phillips screwdriver
over
Cutting tool
Wrench
99-3410
AW -341GO
DW -3410
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR
CHEVROLET
Tracker 1998-04..........................................................1
GEO
Metro 1992-94............................................................1
Tracker 1992-97..........................................................1
SUZUKI
Aerio 2003.................................................................. 2
Esteem 1995-03..........................................................2
Sidekick 1992-98........................................................1
Swift 1992-94............................................................. 1
Vitara series 1999-04.................................................1
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• Please visit www.metraonline.com for specific interface
applications
Antenna Adapter:
• 40-GM10 - GM antenna adapter 88-up
K
NOWLEDGE IS
nhance your installation and fabrication skills
E
by enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 for more information
and take steps toward a better tomorrow.
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001-2009 METRA ELECTRONICS CORP.
PAGE
P
OWER