Advertisement
1
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
2
Unclip and remove the lower center
panel below radio. (Figure A)
3
Remove (1) 8 MM bolt facing up
behind center panel.
Note: Slide the recirculation
control lever to FRESH for better
access to bolt. (Figure A)
4
Open the upper glove box then use
a pry tool to unclip and remove the
radio/climate control assembly.
(Figure B & C)
5
Remove (2) Phillips screws securing
the hazard switch to the back of the
factory radio panel. (Figure D)
6
Remove (2) Phillips screws securing
the air bag light to the back of the
factory radio panel. (Figure E)
7
Remove (5) Phillips screws securing
the a/c vents to the radio panel.
8
Remove (7) retaining clips from radio
housing to be used later in kit
preparation.
Continue to kit preparation.
E
99-7877S DASH DISASSEMBLY
HONDA FIT 2009-10
A
B
C
D
1
Advertisement
