Ask Proxima E2465 User Manual page 46

Advanced setting
Logo PIN code change
Logo PIN code can be changed to your desired three- digit number. Press the SELECT button to select
Logo PIN code change. Logo Pin code dialog box appears, use the Point ▲▼ buttons to enter the
correct code. The New Logo PIN code input dialog box appears. Set a new Logo PIN code, confirmation
box appears, choose yes to set the new Logo Pin code.
Be sure to note the new Logo PIN code and keep it on hand. If you lost the number, you could no longer
change the Logo PIN code setting.
CAUTION:
WHEN YOU HAVE CHANGED THE LOGO PIN CODE, WRITE DOWN THE NEW PIN CODE
IN COLUMN OF THE LOGO PIN CODE NO. MEMO ON PAGE 61, AND KEEP IT SECURELY.
SHOULD THE LOGO PIN CODE BE LOST OR FORGOTTEN, THE LOGO PIN CODE SETTING
CAN NO LONGER BE CHANGED.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management
function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready .................. When the lamp has been fully cooled down, the POWER indicator changes to
green blinking.In this condition, the projection lamp will be turned on if the input
signal is reconnected or any button on the side control or remote control is
pressed.
Shut down .......... When the lamp has been fully cooled down, the power will be turned off.
Off ....................... Power management function is off.
Timer ................... If the input signal is interrupted and no button is pressed for more than 30
seconds, the timer display with No signal appears. It starts the countdown until
the lamp is turned off. Press  buttons to set the Timer(1~30min.)
√ Note:
Factory default is Ready: 5 Min.
46
Power management
No signal
01 : 20
Time left before Lamp is off.