Advanced Setting - Ask Proxima E2465 User Manual

Advanced setting

Advanced setting
You can setting the advanced functions below by the "Advanced setting" menu of the projector.
1 Press MENU button to display the screen
menu. Press  button to select Advanced
setting icon and then press  or OK
button.
2 Press  to select the desired item to be
adjusted, and then press  or OK enter
the item.
3 Press  to select the item, press 
button to adjust.
Language
Set the language used in screen menu.
Menu position
You can use this function to change the
position of screen menu.
Press  select Menu position and press 
or OK to enter the menu position.
Press  to switch the items: Upper left,
Upper right, Center, Lower left, Lower right.
Auto setup
Allows you to perform input search, auto PC
adj, and auto focus, press the AUTOSET
button on the side control or remote control.
The functions can be switched based on the
steps below.
Input search
Allows you to automatically detect input
signals. It stops when a signal is found.
Press to select an option from:
Off........Disabled.
On........Enabled. This function is used to
detect input signals automatically
and stops when finding a signal.
Auto PC adj
On........Press the AUTOSET button on the
top control or remote control to
enable Auto PC adj function
automatically.
Off........Disable.
Auto focus
On........Press the AUTOSET button on the
top control or remote control to
enable Auto focus function
automatically.
Off........Disable.
44
Advanced setting menu
Advanced setting
Language
Menu position
Auto setup
Keystone
Logo
Power management
Closed caption
Security
Filter counter
Warning log
Factory default
Exit - - - - Move
Note:
• Only the last selected input source can be detected.
• If the INPUT button on the top control or on the remote
control is pressed during Input search is in progress,
Input search will stop and go back to the previous
input signal.
• Input Search, Auto PC Adj. cannot be set Off at the same
time.
• Fine sync., Total dots, Horizontal and Vertical position
of some computers cannot be fully adjusted with the
Auto PC Adjustment function. When the image is not
provided properly with this operation, manual adjustments
are required.
Next Next