Tools And Supplies Needed; Inspect Appliance And Components - Quadra-Fire MTVI-E2-MBK Installation Manual

B. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fi replace:
Reciprocating Saw
Hammer
Tape Measure
1/4" Self-Tapping Screws
Hi-temp Caulking Material
Safety Glasses
Electric Drill & Bits (1/4")
May also need:
Vent Support Straps
August 3, 2015
Channel Locks
Phillips Screwdriver
Plumb Line
Framing Material
Gloves
Framing Square
Level
Venting Paint
7082-131J
C. Inspect Appliance and Components
• Open the appliance and remove all the parts and articles
packed inside the Component Pack. Inspect all the parts
and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft cloth,
if applicable.
• Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.
• Follow pipe manufacturer instructions for installation
and air clearance requirements.
WARNING
Risk of Fire!
Damaged parts could impair safe operation.
Do NOT install damaged, incomplete or
substitute components.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• I n s t a l l a t i o n a n d u s e o f a n y d a m a g e d
appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Do NOT Overfi re
Or any such action that may cause a fi re hazard.
NOTE: Upon removing the appliance from the fi replace
a tag shall be permanently attached to the fi replace
indicating it has been altered and should be inspected
by a qualifi ed person prior to re-use as a convectional
fi replace (tag included in component pack).
MT VERNON E2 INSERT
5