Epson Stylus Photo R220 Service Manual page 24

EPSON Stylus Photo R220/R230
LED Indication
Error Status
STM3 Message
Power : --
Paper : Fast Blink
Card Error Ink : --
Unknown error
Occurrence
Timing Phenomenon Detail
Position of CR
Before start to The top edge of the business card is not
print fed to the PF Roller because the business
- card is set in landscape orientation.
TROUBLESHOOTING
Table 1-11. Status and Possible Causes of Card Error
Carriage Unit
Occurrence
Position Faulty Unit/Part Name
Timing
at Power-on
Before start
-
to print
Table 1-12. Card Error Check Points by Phenomenon
Faulty Part/
Part Name
1. Check if the PF Sensor FFC is not disconnected.
PW Sensor
2. Check if the PW Sensor is not damaged.
3. Check if the PW Sensor FFC is not broken.
Main Board 1. Check if any element on the Main Board is not damaged.
Unit Level Troubleshooting
The PW Sensor FFC is disconnected.
PW Sensor PW Sensor failure
The PW Sensor FFC is broken.
Main Board Elements failure
Check Point
PW Sensor FFC
Possible Causes
Remedy
1. Connect the PW Sensor FFC to CN2 on the
CR Encoder Sensor Board.
2. Replace the PW Sensor with a new one.
3. Replace the PW Sensor with a new one.
1. Replace the Main Board with a new one.
Revision A
Remedy
Refer to
Table 1-12
24