Installing A New Assembly Kit (For Expansion From 4 To Max. 8 Drives) - Fujitsu CELSIUS M740 Operating Manual

Installing a new assembly kit (for expansion
from 4 to max. 8 drives)
If you wish to upgrade your device to up to 8 drives, replace the standard assembly
kit C78 with the optional expansion assembly kit C76.
In addition to the cable for the basic configuration, you will also need an expansion cable.
Assignment of expansion assembly kit:
Basic configuration cable:
• Slot EP0 = Connector P0 (Boot-HDD)
• Slot EP1 = Connector P1
• Slot EP2 = Connector P2
• Slot EP3 = Connector P3
Replacing the assembly kit
• Requirements:
There are not any hard disk drives installed in the drive bays.
Otherwise you must first remove the hard disk drives.
• The casing is open (see
• The hard disk fan is removed (see
If you wish to use an installation kit for your hard disks which is other than that which
was installed in your device in the factory, proceed as follows:
Only the relevant components are shown in the following illustrations
for reasons of simplification.
Fujitsu
"Opening the casing", Page
"Remove the hard disk fan", Page
Assignment of expansion assembly kit with
connected connectors:
Expansion cable:
• Slot EP4 = Connector P0*
• Slot EP5 = Connector P1*
• Slot EP6 = Connector P2*
• Slot EP7 = Connector P3*
33).
System expansions
67).
51