Setting Up The Massage Lounger - Panasonic EP-MA10 Operating Instructions Manual

SETTING UP THE MASSAGE LOUNGER
1. Where to use the unit
• Ensure there is adequate space to recline.
• Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because this can
cause discoloration or hardening of the synthetic leather.
Place the unit on a mat to prevent floor damage.
•
• When placing a mat under the unit, the size of the mat should be
sufficient (at least 120 cm × 70 cm) to cover the areas where the unit
touches and where the legrest could touch the floor, as shown in the
diagram on the right.
• Install the unit near a power outlet.
See Warning No. 10 and 12 on page E3.
2. Removing everything from the box and installing the unit
Fabric
Section
Hold the cloth
section on the
Legrest
E10
Place your
fingers in the
groove
backside
Back cover
Keep at least 10 cm away from the wall.
Width approx. 82 cm
Approx.
25 cm
Mat
Area where legrest
could touch the floor
• Since the unit is very heavy (approximately 65 kg), be
careful to avoid back injuries. (The unit must be carried
by two persons.)
• When using the wheels to move the unit, place a mat
on the floor to protect the floor surface.
To put the unit down on the floor
• Put the unit down slowly and carefully watch your step.
• Put down the legrest by holding it with your hands until
it has been set on the floor completely. If you release
Groove
your hands before the legrest is fully extended, the
legrest will forcefully return to the initial position.
Mat
Approx. 181 cm
Approx.
32 cm
Area where unit
touches the floor