Panasonic EP-MA10 Operating Instructions Manual page 40

3. Attaching the side covers (On both the right and left sides)
The method for attaching the covers is the same for both sides.
The diagram shows the right side where the control panel stand is
attached.
1
Insert the bottom tabs on the cover
into the bottom notches on the
armrest.
Removing the side cover
1
Insert a flat-tip screwdriver in the
area above the mark ( ).
2
Push the top tab of the cover
down to lift the cover.
3
Perform the same procedures as
1 and 2 above for the other gap.
4
Pull the cover up diagonally.
• Performing this procedure with the allen key or a
Phillips screwdriver could damage the unit.
• The cover can be removed with light force
instead of forcing it.
4. Connect the power cord to the unit
1
Check for dirt and damage on appliance inlet
of the power switch section and the
connector of the power cord.
2
Insert the connector into the appliance inlet.
3
Be sure to push the connector in all the way.
E14
Bottom tabs
Notches
Right Side Cover
2
Insert the top tabs into the notches on
the armrest.
Right side cover
1
Left Side Cover
Notches
Push the cover until
you hear it click.
Top tabs
Flat-tip screwdriver
2
(Not included in the
standard configuration)
2
Mark
Appliance inlet
Connector
Power cord
Power switch section