Advertisement
Disassembly Tips
shOck and dOGbOne dissassembly Remove the male dogbone
5
pivot pin bolt from the female pivot pin using a 4mm allen key. Use a
punch and a dead blow hammer to remove the female pin from the dogbone
and frame.
shOck and dOGbOne dissassembly Remove the Ti male bolt from
6
the 31.0 female Ti bolt holding the shock on the frame using two 5mm
allen keys. Insert the guide pin tool into the female bolt and use a dead
blow hammer to tap the bolt out of the frame. Be prepared to catch the bolt
as it exits the drive side of the frame
disassembly
28
chanGes We strive to make the best bikes in the world.
Because of this dedication, we continually make changes to
our bikes as needed. As the bikes are improved, assembly
and setup instructions may be affected. Any amendments to
the existing Owner's Manual can be found on our website at
www.yeticycles.com.
axle system Slide the threaded axle through the non drive side of
1
the frame and the hub. Lightly grease the threads on the axle and
tighten into the axle nut on the drive side of the frame with a 5mm allen
key. Torque 40-45 in/lbs
axle system Tighten the pinch bolt on the non drive side dropout to
2
secure the axle. Use a 5mm allen key. Torque 75-85 in/lbs
asr7 frOnt derailleur mOunt Insert the front derailleur mount
1
into the drive side chainstay yoke. Ensure the cable guide on the
mount is facing out.
asr7 frOnt derailleur mOunt Attach the mount with a Ti female
2
M6x16.5 bolt and a M6x1x12 Ti male bolt. Ensure each bolt has the
proper washer installed. Prep the male bolt with locktite and tighten the
assembly with two 5mm allen keys.
Advertisement
