Meridian 541 User Manual page 56

To configure a source
Turn off the control unit, using the power switch on the back
panel.
Turn on the power again while holding down the Display key
on the front panel.
The display will show:
Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
The options are summarised in the table opposite:
50
To change an option
Co nfig
When you have finished programming sources:
CD Mus i c
Press Copy (front panel) or > and < (remote) to change. The
left-hand side of the display shows the source you are
configuring, and the right-hand side shows the current value
of the option.
Press A or V to step between the alternative values for the
option.
Switch off at the back panel, and then switch on again to
restore normal operation.