Meridian 541 User Manual page 43

To select a standard setting
Warning! Selecting Type will reset the 541 Surround Controller
to one of a standard set of configurations. If you want to make
changes to the configuration of an existing system use Config;
see Specifying information about your system on the next page.
With Config you can alter any Type to match any system.
Switch off any power amplifiers that are connected to the
surround controller.
Switch off the surround controller, using the power switch on
the back panel.
Switch on the power again while holding down the Off key on
the front panel.
The display will show:
followed by:
Press A or V on the front panel to change the Type number.
For example, to select Type 3 for use
with a phono module the display shows:
Ty pe
Ty pe 1
Wait for one second, and then switch off the surround
controller using the power switch on the back panel.
Switch on again to use the standard settings you have
selected.
T y p e 3 L P
37