Meridian 541 User Manual page 53

To connect to Meridian 600 or 200
Series equipment
If your system includes any Meridian 600 or 200 Series units,
with 600 COMMS or 200 COMMS sockets, you should set all
the 500 Series units to 200 COMMS operation using the
following procedure:
Turn off the control unit, using the power switch on the back
panel.
Turn on the power again while holding down the Off key on
the front panel.
The display will show the current
Type setting:
Press A and V on the front panel to change the Type setting
to Type 2.
The display will show:
Switch the power off and on again to restore the control unit
to normal operation.
What next?
Congratulations – your 541 Surround Controller is now set up
and ready for use. Refer to the chapter Using the surround
controller for details of using the surround controller with your
music and cinema sources.
Ty pe 1
Ty pe 2
Configure the Meridian System Remote for 601 operation; see
the Meridian System Remote User Guide for details.
To return to 500 COMMS operation repeat the above
procedure, and select any type apart from Type 2. For more
information see Choosing standard settings, page 36.
47