Setting Up Sources - Meridian 541 User Manual

Setting up sources

The 541 Surround Controller provides six sources corresponding
to the following source selection keys on the remote control:
CD, Radio, TV, Tape1 (or LP), VCR1, and LD.
When the surround controller is set to one of the standard
settings the six sources are set up with standard labels and
inputs, as shown in the table below.
Source Audio Sensitivity
Input
CD A2 2.0V
Radio A3 2.0V
TV A5 1.4V
Tape1 A1 1.4V
VCR1 A6 1.4V
LDisc A4 2.0V
LP A1 2.0V
If the configuration you want is not catered for by one of the
standard settings, you can configure each source individually.
For most settings there is a last valid, or L.V., option that leaves
the corresponding setting unchanged from its previous value
when the source is selected. For example, selecting CD after TV
would leave the TV picture.
For each source you can configure:
Video Preset
Input
LV Music
LV Music
V2 ProLogic
The procedure for doing this is as follows.
LV Music
V3 ProLogic
V1 Cinema
Blank Music
The preset to be used.
The label used for it on the front panel display, from over 50
alternative labels.
The audio and video inputs it selects.
The input sensitivity.
The comms type and address, to identify other Meridian 500
Series equipment.
49