Panasonic AJ-PCS060G Operating Instructions Manual page 31

ERROR LED display
Errors that may affect the unit are indicated as follows. Investigate the status and take these corrective actions.
, , : LED lit
REMAIN
No.
1
R
R
2
R
R
3
R
4
R
5
R R
6
R
7
R
8
R
9
R
10
R
11
12
13
R
14
1) To clear the error display, press the [POWER] button and [CANCEL] button together.
, , : LED flashing R : red OR : orange
The internal HDD temperature
is out of operating range.
R
The voltage is low when copying
R
starts.
The remaining charge of the
R battery pack is insufficient
when copying starts.
R R R The voltage is abnormally low.
At the start of copying, there is
R R
not enough HDD space.
At the start of copying, a P2
R R
card is not inserted.
At the start of copying, a
R R
vibration occurred.
At the start of copying, an
error other than insufficient
R R HDD space, a missing P2
card, vibration, and the like
has occurred.
During copying, an error has
occurred. (Other than if the P2
card has been pulled out)
R
A formatting error has occurred
with the P2 card.
(Write-protected)
There is a clip that needs to
be restored on the P2 card.
The data format isn't standard.
R
An unusable P2 card has
been inserted.
Status
Turn the unit OFF and allow it to
cool down before use.
The unit is warming up when [E2]
flashes. Go to a warmer area.
Replace with a fully charged,
optional battery pack or switch to
the use of an optional AC adaptor.
After clearing the error display
format the internal HDD. If it
contains data you need, back up
the data on a different storage
media before formatting.
After clearing the error display
insert the P2 card, and copy.
After clearing the error display
place the unit on a stable surface.
After the vibration has stopped,
you can resume use.
After clearing the error display
try copying the data again. If the
error recurs, switch P2 cards and
try copying again. If the error
persists even after this, contact
the place of purchase.
After clearing the error display
set the write-protect switch to the
opposite side from the PROTECT
position.
(See page E-14)
After clearing the error display
restore a clip using a P2 camera-
recorder or other device before use.
After clearing the error display
try formatting the card again. If
the error persists even after this,
contact the place of purchase.
After clearing the error display
you can resume use.
For further details about P2 cards,
contact the place of purchase.
Corrective Action
1)
,
1)
,
1)
1) ,
1) ,
1) ,
,
,
1)
1) ,
E-30