Panasonic AJ-PCS060G Operating Instructions Manual page 15

Copying (continued)
Write-protection on P2 cards
When P2 cards are inserted, the following operations will be prevented to protect the data, even if
you adjust the write-protect switch. Thus, check the write-protect switch before inserting P2
cards.
HDD capacity indicator
Up to 15 P2 cards worth of data can be copied to the unit's internal HDD. (However, in the case
of 8 GB P2 cards, the data on only 7 P2 cards can be copied.) To see how much space is
available on the HDD (how many cards can be copied), press the [HDD CAP] button and check
the [REMAIN] indicator.
See【HDD Capacity (in Number of Cards)】 .
With the unit ON, check how many P2 cards can be copied
Press the [HDD CAP] button the number of times indicated (Press count) in [HDD Capacity (Settings)]
below. This will depend on the type of P2 card inserted.
The [REMAIN] LED will light in orange for a second and then the display will change to that
shown in [HDD Capacity (in Number of Cards)] below.
【HDD Capacity (Settings)】
: LED lit OR : orange
Press
P2 card type
count
2 GB/4 GB 1
8 GB 2
16 GB 3
【HDD Capacity (in Number of Cards)】
: LED lit : LED flashing R : red G : green
Capacity
(No. of cards that
can be copied)
0
1
2
3
4
5 or more
Full useable
(when the cards are not in use)
The [REMAIN] indicator goes out after about 2 seconds.
Write-protect switch settings
： Data cannot be written to or deleted from
PROTECT
： Data may be written to or deleted from
PROTECT
REMAIN
OR
OR OR
OR OR OR
REMAIN
R R
G
G G
G G
G G
G G
G G
the card.
the card.
R R R
G
G G
G G G
G G G
E-14