Using Your Humidifier - Kenmore 758.15420011 Use & Care Manual

Operating the Controls (continued)
The SET readout has a range of 25% to
65% and is adjusted in increments of
5%. Initially depressing the humidity
button will display the current humidity
setting.
Each additional press of the button
increases the setting by 5%. A SET point
of 65% operates the humidifier
continuously regardless of the ROOM
reading. The humidistat that senses the
readings is located on the power cord.
Insure that this humidistat is free from
obstruction.
Humidity Button\
Using Your Humidifier
Refill Display and Auto Dry Out
Function
For maximum run time both bottles
should be filled. When both bottles are
empty the display alternates the room
humidity reading and "F" (FILL),
indicating additional water is required;
Also at this time the unit will auto-
matically switch into AUTO DRY OUT
MODE and continue to run on the
lowest speed until the filter is dry.
Refil!/Auto Dry Out
Mode Display
NOTE= During this time the room
humidity level will continue to be
monitored and the humidifier will cycle
the fan on and off until the filter is
completely dry. The fan will shut off
leaving you with a dry humidifier that is
less prone to mold and mildew growth.
If AUTO DRY OUT MODE is not desired,
refill the humidifier with water and the
fan will return to the set speed.
9
NOTE= Fan automatically switches to
lowest speed during AUTO DRY OUT
MODE.
Manual Dry Out
At the end of the humidification season
or if you do not plan to run the
humidifier for one week or more, a
manual dry out mechanism is provided
to completely dry out the humidifier
cabinet.
To do this, simply slide the float retainer
located at the back of the humidifier
cabinet to the top position of the slot it
is located in. This will hold the float in
an upward position and the fan will run
until you turn the power off.
NOTE= Be sure to position float retainer
to the normal operating mode (lowest
position in slot) for normal humidifier
operation.
Below is a diagram of the slot the float
retainer is located in, at the back of the
cabinet.
Back of Cabinet Top Position
is for Manual
Dryout
Bottom Position
is for Normal
Operation Mode
Float
Retainer
Slot