Advertisement
A space is reserved for a 3.5" floppy disk drive on the top of the
device bay. Follow the procedures below to install a 3.5" floppy disk
drive.
1. Fasten one pair of mounting brackets to both sides of a 3.5" floppy
disk drive. Note that the guide edges of the mounting brackets
should be on the lower side.
2. Unfasten and remove the top cover plate of the device tray.
3. Insert the floppy disk drive with attached mounting brackets into
the device tray.
4. Fasten the mounting brackets to the device bay.
5. Open the back cover of the chassis, and connect the cables to the
installed device and to the rear transition board.
6. Close the back cover.
Advertisement
