Advertisement
Follow the procedures below to install a 5.25"/3.5" device:
1. Fasten one pair of mounting brackets to both sides of a 5.25" device
(or a 3.5" device with extension brackets). Note that the guide
edges of the mounting brackets should be on the lower side.
2. Unfasten and remove the cover plate of the device tray.
3. Insert the device with attached mounting brackets into the device
tray.
4. Fasten the mounting brackets to the device bay, and then fasten the
cover plate (for internal devices only).
5. Open the back cover of the chassis, and connect the cables to the
installed device and to the rear transition board.
6. Close the back cover.
Advertisement
