Advertisement
Before operating your system, first check your power supply source.
Adjust the switch on the power supply to the correct voltage.
Two mounting flanges are included for users who would like to install
the MIC-3032/8 on a 19" rack or on a panel. These flanges can be
installed on the front side for rack mounting or on the rear side for
panel mounting.
Four rubber stands can be attached to the bottom of the chassis for
desktop operation. They are not required for rack mounting.
The device bay of the MIC-3032/8 accepts four devices, including
three 5.25"/3.5" devices and one 3.5" floppy disk drive. If the lower
two trays in the device bay are not occupied by power supplies, the
device bay may accommodate two more devices.
There are two types of mounting brackets shipped with the MIC-3032/
8. Three pairs of mounting brackets are designed for mounting 5.25"
devices such as hard disk drives or CD-ROM drives. Please refer to
Figure 2-4 for an illustration of mounting. However, if users would like
to use a 3.5" hard disk drive in the MIC-3032/8, extension brackets
(3.5" to 5.25") are required. These extension brackets are commonly
available in PC shops, or users can contact an Advantech distributor
to order them. For mounting a 3.5" floppy disk drive, a pair of mount-
ing brackets are provided. Users can mount the floppy disk drive on
the top tray in the device bay. Please refer to Figure 2-5 for an illustra-
tion of mounting. Figure 2-6 shows the recommended device bay
configuration.
Advertisement
