Table of Contents
Advertisement
other dial-up devices.
• It is recommended that the router first be configured with the ethernet cable
connected prior to setting the wireless functions.
NOTE: This setup wizard can be run in Windows 98se, Me, 2000 or xP. The
following procedures represent Windows xP, but are similar for 98se/Me/2000.
1. Insert the enclosed setup Cd (featuring the setup wizard) into your Cd-RoM
drive. The autorun.exe program should be executed automatically. If not,
run autorun.exe manually from the "autorun" folder on the Cd.
2. Click on "setup Wizard"
when the initial menu
appears on screen. The
wizard will search for
the router. If the router
can't be found, enter the
IP address and the
password of the router,
then click "next" to
search again.
3. The following instructions are based on the successive prompts that will
appear. First, select the country in which the router is being installed, then
click "next."
4. select your IsP.
5. If needed, enter the username and password provided by your IsP, then
click "next."
6. When the settings overview screen appears, click "save," which will
reboot the router.
after saving and rebooting,
the IsP settings are complete.
Click "Finish" to close the
setup wizard.
To configure additional
settings, click "advanced
settings" and proceed to
the IP address setting
section in the user manual.
NOTE: To use the router to access the Internet, the IP address of each PC
has to be set in the same subnet as the router. This wizard will help to set the
proper IP address(es).
NOTE: by default, the router's dHCP server is enabled. If it is disabled before
running the setup wizard, the wizard will automatically enable it.
Advertisement
Table of Contents
