Cadet EP101T Owner's Manual

Energy plus heater

Advertisement

energy
and adjusts automatically to save you money
perature within one degree
• Our most thoughtful design features:
Large digital display shows your room temperature
and heating mode
Night/Away option for extra savings
with three fan speeds
• Common sense components designed with you in
mind:
Peace of mind safety with automatic high
temperature shutoff
No sharp edges
Corrosion resistant
Our sturdiest element provides comfortable warmth
for years of reliable use
• Your Energy Plus heater has been thoroughly tested
and is guaranteed with a
COM-PAK
TOOLS REQUIRED:
• Phillips Screwdriver
• Straight Screwdriver
• Wire Strippers
cadetheat.com
-
PATENT PENDING
• Utility Knife
• (4) 1½" Wood Screws
• (2) Insulated Wire Connectors
• (1) Strain Relief Connector
SAVE THESE INSTRUCTIONS
Tel: 855.CADETUS
Energy Plus Heater
Owner's Guide
Information is also available on our website:
http://www.cadetheat.com/products/wall-heaters/energy-plus
120
Rating Label
Controller with Digital Display
and Push Buttons
Side
Grill Front
+
NO
F
NO
HEAT
SLEEP
FAN
HEAT
ONLY
5
/
"
9"
8
1.6cm
22.9cm
Wall Can Bottom
7
7
/
"
8
20.0cm
3"
7.6cm
1¾"
4.5cm
PO Box 1675 Vancouver, WA
1000
Energy Plus Model With Built-In Controller
072xxx
NO
F
NO
HEAT
Wall Can Side
1
11
/
"
12"
8
30.5cm
28.3cm
3¼"
8.3cm
4"
10.2cm
Conforms to UL Std.
1¼"
CAN/CSA Std. C22.2
3.2cm
98668-1675
8.3
10"
25.4cm
1¼"
3.2cm
No. 46
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Cadet EP101T

  • Page 1 Energy Plus Heater Owner’s Guide Information is also available on our website: http://www.cadetheat.com/products/wall-heaters/energy-plus • energy • 1000 and adjusts automatically to save you money • perature within one degree Energy Plus Model With Built-In Controller • Our most thoughtful design features: Large digital display shows your room temperature and heating mode Night/Away option for extra savings...
  • Page 2: Important Instructions

    IMPORTANT INSTRUCTIONS 1. Read all instructions before installing or using this heater. Risk of Electrical Shock. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or Risk of Fire. This heater is hot when in use. block air intakes or exhaust in any manner.
  • Page 3 The Cadet Energy Plus heater is designed to save energy and run at a low speed and heat output once the desired room temperature is reached. This is normal operation for maintaining and regulating desired room temperature. This low speed fan movement also provides better...
  • Page 4: Installation Instructions

    INSTALLATION INSTRUCTIONS Verify that the electrical supply wires are the same voltage as the heater. or anywhere the air discharge may be blocked in of the old heater. any manner. Fire or Explosion May Occur. A heater has hot and arcing or sparking parts inside. Do not use it state and local codes.
  • Page 5 INSTALLATION INSTRUCTIONS (continued) __________________________ __________________________ STEP 1 How do I insert the heater assembly into the wall can? STEP 2 Connect the supply wires to the heater wires with wire connectors (not included). (See Figure 6). Now rotate heater assembly into wall Push wires into bottom and left side of wall can during insertion.
  • Page 6 OPERATING INSTRUCTIONS Risk of Electrical Shock and Fire. The heater must be properly installed before it is used. at circuit breaker panel before removing grill. 1. Do not operate without grill. to blow debris through the top element (do not touch element).
  • Page 7: Fault Codes

    4. If the date of manufacture of the product cannot be determined; 6. The use of unauthorized accessories or unauthorized components Visit cadetheat.com/parts-service for information on where to obtain parts constitutes an alteration and voids all warranties. Refer to Cadet website and service. ries and components.
  • Page 8: Maintaining Your Heater

    MAINTAINING YOUR HEATER Maintenance As Needed, or every six months minimum. (circuit breaker or fuse box). Lock or tag the main disconnect panel door to prevent someone from accidentally turning the power on while you are working on the heater. Failure to do so Any other service not detailed in this Owner’s Guide should be performed by an autho- rized service representative.

Table of Contents