Erasing Personal Code; Unlocking The Doors With The Keyless Entry System; Locking The Doors With The Keyless Entry System; Autolock - Mercury Mountaineer 2001 Owner's Manual

Controls and features
If you wish to erase your personal code, use the following instructions:

Erasing personal code

1. Enter the factory-set code.
2. Press 1/2 within five seconds of
step 1.
3. Press the 7/8 and 9/0 controls at
the same time within five seconds of
step 2.
The system will now only respond
to the factory-set code.

Unlocking the doors with the keyless entry system

To unlock the driver's door, enter either the factory-set code or personal
code (each digit pressed within five seconds of the prior digit). The
interior lamps will illuminate.
To unlock all doors, enter the
factory-set code or personal code
(driver door unlocks) and press the
3/4 control within five seconds.

Locking the doors with the keyless entry system

To lock all the doors, press 7/8 and
9/0 at the same time. It is not
necessary to first enter the keypad
code.

Autolock

The autolock feature will lock all of the vehicle doors when:
all doors are closed
the engine is running and
you shift into any gear putting the vehicle in motion
108
3 4
1 2 5 6
1 2 3 4 5 6
1 2 3 4 5 6
7 8 9 0
7 8 9 0
7 8 9 0