Wing - THUNDER TIGER hawk 1400 Assembly Manual

ASSEMBLY / WING
Wing Assembly
1. Locate CA Hinges and use pins to center the
hinges in place.
2. Install the aileron and remove all pins then apply
thin CA to all hinge areas.
3. Remove the portion of center wing rib to allow
clearance for aileron servo. Repeat the same
process on the other wing .
4. Trial fit two wing halves with Wing Join Wire. When
satisfied, apply epoxy to two center wing ribs then
accurately aligned and firmly press with each other
until it cured.
5. Cut plywood Wing Mount into two pieces with
hobby knife. Trail fit the wing mounts in fuselage.
Sand the glue area in fuselage to enhance
adhesion. Upside down the fuselage then glue
wing mounts in place with epoxy.