Tail - THUNDER TIGER hawk 1400 Assembly Manual

6. Mark a centerline and wing mounting holes on
Wing Protector as shown.
7. Place wing protector on the main wing and make
sure it is centered and level with trailing edge. Use
fine tip marker to make mark along the wing
protector.
8. Use hobby knife to cut away the covering inside the
line about 1/8"(3mm). Be carefully do not hurt the
wood structure.
9. CA the wing protector. Trial fit the main wing onto
the fuselage, then drill 3/64"(2mm) holes at the
marks you drew before. Secure the main wing
with furnished wing mounting wood screws.
Tail Installation
110˚
10.Trail fit two tails to the fuselage, sand it if
necessar y. Epoxy the tails as shown, use
furnished template to make sure the two tails is
angled 110-degree.
ASSEMBLY / TAIL