Table of Contents
Advertisement
PARTS CHECK LIST
Kit Contents:
Fuselage(1)
Canopy(1)
1/4" Blind Nut(2)
Cockpit(1)
Fillet(1/L,1/R)
Radiator Vent (1)
Straight Threaded End(2)
Clevis(4)
Left Wing(1)
Z-Bend Threaded End(2)
Right Wing(1)
Aileron Pushrod(2)
Retract Servo Mount(4)
Inner Tube(1/L,1/S)
Landing Gear Mount(2)
Guide Tube(1)
Scoop(1)
Throttle Pushrod(1)
Fairing(1)
Retract Gear Pushrod(2)
Plywood Wing Joiners(3)
Servo Case(2)
Tail Gear(1)
Wing Bolt(2)
Tail Wheel(1)
Machine Guns(2)
Collar(1)
Radiator(1)
Control Horn(4)
Horizontal Tail
Back Plate(4)
Elevator Joiner
CA Hinge(6)
Vertical Fin/Rudder(1)
CA Hinge(3)
Wheel(2)
Spinner(1)
Fuel Tank(1)
Spinner Back Plate(1)
Silicon Tub(1)
Fuel Stopper(1)
Straight Nipple(1)
OBL Motor Mount(1)
Cap(1)
Sink Head Screw(4)
Crank Weight(1)
90-Degree Nipple(1)
Cowling(1)
Exhaust Vent(2)
EZ Connector(1)
1.5mm Hex Wrench(1)
Captain Eddy(1)
Main Gear Wire(1)
Landing Gear Strap(4)
Collar(2)
Wheel Well(1/L,1/R)
Wheel Door(1/L,1/R)
Wheel Door Retainer
Left Mount Beam(1)
Right Mount Beam(1)
Engine Mount Plate(1)
E Clip(2)
Retract Servo Link(2)
Wheel Door Retainer
M2 Washer(1)
M2 Nut(3)
2X20 Screw(4)
2X15 Screw(4)
3X5mm Screw(2)
3X3mm Set Screw(2)
6/32X18mm Screw(4)
6/32X24 Screw(4)
3X12mm Wood Screw(9)
3X15mm Wood Screw(1)
3X18mm Wood Screw(4)
2X8mm Washer Wood Screw(19)
3X15mm Self-Tapping Screw(4)
3X16mm Sink Wood Screw(8)
6
1.
Remove aileron from the wing, CA three hinges on the
aileron.
2.
Next attach the aileron on to the wing and apply CA to
the hinge area. Make sure the aileron is firmly secured
in place.
3.
With the wing panel upside down, locate the servo well
and cut an X from corner to corner by using an hobby knife.
WING
4.
Use a sealing iron to tack down the covering inside
the servo well.
5.
Secure the aileron servo in place, the hatch cover
shown is for left wing.
Connect servo to RX and turn on radio to make sure
servo is in neutral position then secure the control horn.
6.
Attach the 12" aileron extension lead to the servo and
tape the connector to prevent from loosening. Locate a
string which is in the servo well, tie the string on the
connector and use mask tape to tape the connector so it
is easier to pass through the ribs.
7
Advertisement
Table of Contents
