Wing; Left - THUNDER TIGER Sept. Fury Assembly Manual

WING

7. Use Throttle Pushrod to guide the wire through the
wing panels. Fix the wire with mask tape to prevent from
falling back into wing pannel.
8. Link aileron servos wires to CH1 on receiver. Make
sure the direction is correct. Set the servo horn in the
neutral then secure the servo horn screw next secure
the servo case in place with four 2.3x12mm washer
wood screws.
9.Please note that the aileron is thick; carefully drill the
(5/64")2mm holes and make sure the back plate is flush
with the hinge line at the other side of aileron. Secure
the control horn in place with 2x22 machine screws.
Trim away the excess screw from the backplate. Install
the pushrod with metal clevis, M2 nut and thread on a
piece of silicone tube asshown.
10. If you would use Flap function then proceed the
following steps. If not then skip to step 24. Do the same
procedure for Flap Servo Case. (Left Flap Servo Case
shown) and thread the wire through the wing panel and
tape the wire end on wing root.
11. Temporally secure the Flap Servo Case in place
with 2.3x12mm Washer Wood Screws.
12. Carefully cut away covering. The knife may lean
against the flap then carefully cut along with the flap
leading edge.
8
Flap II
Flap I
13. Next cut away the covering between Flap I and Flap II.
14. Carefully cut away the flap from trailing edge.
15. Iron the covering at the trailing edge.
WING
16. Locate the joiner wire and guide tube. Make mark at
the center of the joiner side of the Flap I and Flap II.
17. Carefully drilling the joiner side at mark. Note that it
is angle at the joiner side please drill the hole perpend-
icular to the surface. Drill 2.5mm hole on Flap I and 2mm
hole on Flap II.
Flap II
Flap I
18. Insert guide tube in Flap I and light apply CA glue.
Glue threaded end of joiner wire in Flap II, also apply a
drop of CA glue. Cut two hinge slots and glue CA hinges
in place.
9