THUNDER TIGER hawk 1400 Assembly Manual page 9

ASSEMBLY / SERVO
22. Install EZ Connector on servo horn.
23. Insert the pushrod through the EZ connector,
make sure elevator is level with the tail then secure
the servo horn and set screw when servo is in
neutral position.
24. Locate Vecro and cut it into two pieces. Attach the
vecro to battery pack and attach the other halves
of vecro to the fuselage as shown.
25. Refer to manufacturer's Receiver and ESC manual
then connect all connectors properly. The ESC
and RX are located between battery and motor.
You might need two servo extensions at this step.
Install the switch on fuselage as shown. Thread
the antenna though fuselage and explode at least
5"(10cm) in length out of of fuselage.
ACE R/C
TR-402A
BATT
4CH AM RECEIVER
CH.1
27
CH.2
MHZ
CH.3
NARROW BAND
CH.4
ACE
ESC-30
7.2-8.4V Battery
26. The attached two pictures are the examples for
using ESC-30 and auto cut-off.
7.2-8.4V Battery
ACE R/C
TR-202A
BATT
4CH AM RECEIVER
27 CH.1
MHZ
CH.2
NARROW BAND
M+ B+
START
SW
Auto Cutoff
BEC
CONTINOUS CURRENT :30A(MAX)
M- INPUT VOLTAGE:7.2-8.4V
B-