Servo - THUNDER TIGER hawk 1400 Assembly Manual

17. Install the Folding Propeller. Make sure there is
1/16"(1.5mm) clearance between back plate and
fuselage.
Servo Installation
18. Locate Aileron Servo Tray, cut away the covering
then glue the servo tray and install the aileron

servo.

ASSEMBLY / SERVO
19. Install the nylon horn to aileron torque rod.
Thread clevis to pushrod then connect the clevis
to nylon horn. Z-bend the pushrod at the proper
position then connect to the servo horn. You will
have to remove the servo horn from the servo to
do this step.
Enlarge the servo horn holes for pushrod to go in
might be necessary.
Adjust the clevises when servo in neutral position,
apply tube to hold clevis in place when satisfied.
20. Secure the elevator servo on the servo tray as
shown.
21. Glue the ser vo tray in fuselage with CA as
required position.