Qxd 12/28/2011 2:49 Pm - Tripp Lite SmartPro Owner's Manual

201112107 93-2773.qxd 12/28/2011 2:49 PM Page 7
Basic Operation
(continued)
Other UPS Features
Voltage DIP Switch (Select Models): This switch enables you to set the
UPS to match actual input voltage. If the Voltage DIP Switch is set above
or below the actual input voltage, the UPS will treat the input as a
continuous overvoltage or undervoltage condition, and will automatically
adjust input voltage to match the Voltage Dip Switch setting. This will
cause constant, unnecessary wear on the UPS system. Note: The Voltage
DIP Switch must be set with the UPS turned OFF and disconnected
from utility power. If the switch is set while the UPS is connected to
utility power, the setting will not take effect.
AC Outlets: These outlets provide your connected equipment with AC
line power during normal operation and battery power during power
outages. The UPS protects equipment connected to these outlets against
damaging surges and line noise.
NEMA 5-15R
Communication Ports (USB and RS-232): These ports connect your
UPS to a workstation or server. Use with Tripp Lite's PowerAlert Software
and included cables to enable your computer to automatically save open
files and shut down equipment during a blackout. Also use PowerAlert
USB
Software to monitor a wide variety of AC line power and UPS operating
conditions. Consult your PowerAlert Software manual or contact
Tripp Lite Customer Support for more information. See "USB
RS-232 (DB9)
Communications" and "RS-232 Serial Communications" in the "Optional
Installation" section for installation instructions.
Telephone/Network Protection Jacks: These RJ45 jacks protect your
equipment against surges over a telephone/network data line. Connecting
your equipment to these jacks is optional. Your UPS will work properly
without this connection.
Accessory Slot: Remove the small cover panel from this slot to install
optional accessories to remotely monitor and control your UPS. Refer to
your accessory's manual for installation instructions. Contact Tripp Lite
Customer Support at (773) 869-1234 for more information, including a list
of available SNMP, networking management and connectivity products.
Fan: The fan cools the internal components.
Input Breaker (Select Models): Protect your electrical equipment from
overcurrent draw from the UPS load. If this breaker trips, remove some of
the load, then reset it by pressing the breaker in.
7