Quick Installation - Tripp Lite SmartPro Owner's Manual

201112107 93-2773.qxd

Quick Installation

Note: The illustrations may differ somewhat from
your model.
1 (Select
disconnected from utility power, use a
small tool to set the Voltage Dip
Switch to match your input voltage.
(All models are preset to the 120V
setting.)
2
Plug the UPS into an outlet on a
dedicated circuit.
NOTE! after you plug the UPS into a live AC
outlet, the UPS will automatically charge its
batteries,* but will not supply power to its outlets
until it is turned ON.
* The BATTERY CHARGE LED will be the only LED illuminated
3
Plug your equipment into the UPS.
Note: Your UPS is designed to support electronic
equipment only. You will overload the UPS if the
total VA rating for all equipment connected
exceeds the UPS Output Capacity. To find your
equipment's VA ratings, look on the nameplates. If
the equipment is listed in amps, multiply the
number of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA). If you are
unsure if you have overloaded the UPS, see
"OUTPUT LOAD LEVEL" LED description.
4
Turn the UPS ON.
Press and hold the "STANDBY" button
one second. The alarm will beep once briefly after
one second has passed. Release the button.
12/28/2011 2:49 PM
Models) With the
Page 3
UPS
1
2
3
A
4
for
A
3