Table of Contents
Advertisement
7902 - 7905 | Installation and Operational Manual
EN | 6
If the automatic camera sequence is active, it stops at the camera
input in question.
INSTALLATION
Remark: When the system configuration is altered, the system
monitor needs to check and memorize the configuration of the
cameras and accessories connected to its inputs.
This is done automatically when the power is switched on. Use the
power switch to switch off. Operating the power save key is not
sufficient.
If switching off is impracticable, use the auto install option of the
system monitor's install menu.
Mounting the box
1. Loosen the screw holding the cover and remove the cover.
CL 66610005_501.AI
2. Remove the circuit board1.
3. Fasten the bottom plate of the box with two screws.
Bosch Security Systems | 2004-06
Advertisement
Table of Contents
