Premounting Of Shifting Fork - Bukh DV36/48 Workshop Manual

R24
Picture No. 37 continued
Measuring example:
Thickness of intermediate washer during the measuring procedure:
Measured axial clearance of shaft:
Correct tightening 0.03 – 0.08 mm (average value):
Thickness of compressed liquid jointing:
Theoretical thickness of intermediate washer:
In practice the intermediate washer will be 0.73 – 0.78 mm.
Then insert the correct intermediate washers in the bores (max. 2 washers in each bore)
and fit the bearing outer collars after heating with Loctite No. 601.
Pre-Mounting of Shifting Fork.
Place the reversing shaft in the shifting fork and secure it with the threaded pin and smear it
with Loctite No. 241.
"NOTE": the long side of the reversing shaft points to the left when the position of the
shifting fork is as shown on the drawing.
009W2229
0.60 mm
0.08 mm
0.055 mm
0.02 mm
0.755 mm